My home network is rather small: two desktop machines and one laptop. Access to outside world is done via usual ADSL connection. Bridge between two worlds was some unknown ADSL router connected to (good old) LinkSys WRT54G with custom DD WRT firmware; all work was done here: firewall, port forwarding, dhcp …
This combination was good, but not the best – main obstacles were having two devices instead of one (WRT54G has no ADSL port) and no VPN directly to offices where I work.
Recently, I replaced WRT54G with newer model: LinkSys WAG325N: ADSL port, 4 LAN ports, 802.11 a/b/g wireless and experimental (draft) implementation of 802.11n wireless protocol. Best of all, up to 5 VPN channels directly from router, so all machines can use VPN tunnel w/o problems.
After seting up VPN, access to business machines was just fine from desktop machines. However, that was not the case for laptop, which is using wireless connection.
Using Remote Desktop from laptop, I would see initial black or blue screen of remote computer (w/o login box) and after couple of minutes, Remote Desktop session would die.
After considerable time spend on Google (and with great help of our system administrator Nemanja), I found possible problem: size of MTU or Maximum Transmition Unit – size of the largest packed allowed on particular network.
Default size set by Windows Vista was 1500 and that was enought not to establish Remote Desktop connection over VPN. In Vista, you can check settings by going in Command Prompt and typing:
netsh interface ipv4 show subinterfaces
and you will get something like:
MTU MediaSenseState Bytes In Bytes Out Interface
------ --------------- --------- --------- -------------
4294967295 1 0 7127 Loopback Pseudo-Interface 1
1500 1 145661 51022 Wireless Network Connection
1500 5 0 0 Local Area Connection
1500 5 0 0 Bluetooth Network Connection
Now, you can change MTU for particular interface:
netsh interface ipv4 set subinterface "Wireless Network Connection" mtu=1440 store=persistent
(make sure that you are doing this from elevated Command Prompt, i.e. CMD started using right-click and option “Run as Administrator“) and that will sort out any Remote Desktop connection problems.